Add new device

Add new device

To add a new device, press "+" in the "devices” section, the device activation wizard starts.

AKODATA device activation wizard

A wizard guides you through the device registration process:

Enter the serial number and device valid. code / IMEI or click on the QR button to activate the camera and read the device QR.

Check the acceptance of conditions box and press "Activate equipment".

Activate the physical device to start communication with the cloud. Wait a few minutes until the cloud receives the communication.

Choose the most appropriate application according to the intended use of the device.

Choose between applying a preset (set of parameters previously saved) or start a wizard to configure the device.

Once the steps have been completed, fill in device information with the data you consider necessary and click on Save equipment data.

Upon completion, it is recommended that you force a transmission of the device by clicking the button for more than 3 seconds to apply the configuration carried out.

From this moment on, the device starts to send data to Akonet.cloud periodically depending on configuration.

AKOGAS device activation wizard

A wizard guides you through the device registration process:

Enter the serial number and device validation code (IMEI) or click on the QR button to activate the camera and read the device QR.

Check the acceptance of conditions box and press "Activate equipment".

Force a transmission to start communication with the cloud. Wait a few minutes until the cloud receives the communication.

Once the steps have been completed, fill in device information with the data you consider necessary and click on Save equipment data.

From this moment on, the device starts to send data to Akonet.cloud periodically depending on configuration.

AKONet.Edge device activation wizard

A wizard guides you through the device registration process:

Enter the serial number and device validation code or click on the QR button to activate the camera and read the device QR.

Check the acceptance of conditions box and press "Activate equipment".

Once the steps have been completed, fill in device information with the data you consider necessary and click on Save equipment data.

If the AKONet.Edge is running and connected to the Internet (Ethernet or GPRS), the start searching for connected devices screen is displayed.